DODGE RAM TRUCKS & RAM CHARGER
Dodge used different types of drive shafts stock from the factory. Please see below for examples and how to measure.
FRONT DRIVE SHAFTS
|Figure 1: Double Cardan Yoke at T-Case. Type A drive shaft with standard spline $269.00 with X spline, $299.00 using 1310 series u-joints.
Measure length as per Figure 3.|
|Figure 2: Double Cardan Flanged at T-Case. Type A drive shaft with flange at C.V. end with standard spline $319.00 with X spline, $349.00
using 1310 series u-joints. Measure length as per Figure 4.|
Measure for Length and U-Joint Size
|Figure 3: Fixed yoke to fixed yoke|
|Figure 4: Flanged yoke to fixed yoke|
|Figure 5: U-Joint size|
|Figure 6: Spline/Slip Yoke Differences|
Newer ¾ & 1 Ton Front Drive Shafts (with double cardan and flanged both ends)
|Figure 7: Double Cardan Flanged both ends newer ¾ & 1 ton front drive shafts. Starting at $479.00|
|Figure 8: Measure length for flanged yoke to flanged yoke|
|Figure 9: If the differential flange is not the serrated type, we will need to know flange A, B, C1 & C2 dimensions.|
Type B Front Drive Shaft
|Figure 10: Starting at $219.00 on 2” tube using 1310 series u-joints. Please call with your dimensions for more detailed pricing.|
|Figure 11: Measure length of fixed yoke to fixed yoke|
|Figure 12: U-Joint size|
DODGE 1500 Front Type AC Drive Shaft
|Figure 13: Stock drive shaft|
|Figure 14: Replacement Drive shaft for newer ½ tons. Starting at $389.00
|Figure 15: Measure length for reverse slip to flanged yoke|
|Figure 16: For the Flange we will need to know the A, B, C1 & C2 dimensions.|
Rear Drive Shaft
Please note we cannot build drive shafts longer than 75” also, we do not build or balance 2 Piece type drive shafts with the carrier bearing.
Please follow our measuring guide so the correct drive shaft can be built.
click here Download entire detailed PDF Measuring Guideclick here
Dodge used many different types of drive shafts stock from the factory over the years.
|Figure 17: Type B shaft|
|Figure 18: Type C shaft|
|Figure 19: Length measurement|
|Figure 20: U-Joint size|
|Figure 21: For the Flange we will need to know the A, B, C1 & C2 dimensions.|
|Figure 22: CV Drive Shaft|
|Figure 23: Conventional two joint drive shaft |
Free Shipping - click here for more
|Note: Most drive
shafts shown in photos are polished and clear coated, this finish adds
$25 the cost. We only recommend the polish & clear coat for show
vehicles or very dry climates.
Questions? Give us a call!
Tom Wood's Custom Drive Shafts |
Copyright © 1999-2017
We reserve the right to change prices, or not sell an item, due to error in
[HOME] Tom Wood's Custom Drive Shaft's [HOME]